LG UX96 Serie Manual De Instrucciones página 21

Satellite dish connection
(Only satellite models)
Connect the TV to a satellite dish to a satellite socket with a satellite RF
cable (75 Ω).
Euro scart connection
(Depending on model)
Transmits the video and audio signals from an external device to the
TV set. Connect the external device and the TV set with the euro scart
cable.
Output Type
Current
input mode
Digital TV
Analogue TV, AV
HDMI
1 TV Out : Outputs Analogue TV or Digital TV signals.
• Any Euro scart cable used must be signal shielded.
• When watching digital TV in 3D imaging mode, only 2D out signals
can be output through the SCART cable. (Only 3D models)
CI module connection
(Depending on model)
View the encrypted (pay) services in digital TV mode.
• Check if the CI module is inserted into the PCMCIA card slot in the
right direction. If the module is not inserted properly, this can
cause damage to the TV and the PCMCIA card slot.
• If the TV does not display any video and audio when CI+ CAM is
connected, please contact to the Terrestrial/Cable/Satellite Service
Operator.
USB connection
(Depending on model)
Some USB Hubs may not work. If a USB device connected through a USB
Hub is not detected, connect it directly to the USB port on the TV.
Speaker output setup
AV
(TV Out )
1
Digital TV
Analogue TV
• Do not connect your headphones or earphones to the port for
• Use only with the 3 Pole 3.5mm Stereo Jack.
Method of volume control port
* Cable Spec.
Control port for Speaker out
UP
DOWN
NOTE
connecting an external speaker.
Each Up/ Down pin is pulled to 3.3V
with CPU GPIO.
GND / UP / Down
CPU detects transition from 3.3V
to GND level for volume control.
+
-
GND
RIGHT
LEFT
GND
13