Safety Notes - SICK WSE9-3 Instrucciones De Operación

Through-beam photoelectric sensor
1

Safety notes

2 Correct use
3 Commissioning
8017641 | SICK
Subject to change without notice
Operating instructions
Read the operating instructions before commissioning.
■
Connection, mounting, and setting may only be performed by trained specialists.
■
Not a safety component in accordance with the EU Machinery Directive.
■
UL: Only for use in applications in accordance with NFPA 79. Adapters listed by UL
■
with connection cables are available. Enclosure type 1.
When commissioning, protect the device from moisture and contamination.
■
These operating instructions contain information required during the life cycle of
■
the sensor.
The WSE9(M4)-3 is an opto-electronic through-beam photoelectric sensor (referred to
as "sensor" in the following) for the optical, non-contact detection of objects, animals,
and persons. A sender (WS) and a receiver (WE) are required for operation. If the pro‐
duct is used for any other purpose or modified in any way, any warranty claim against
SICK AG shall become void.
1 Observe the application conditions: Adjust the distance between the sender and
the receiver according to the corresponding diagram [H] (x = sensing range, y =
operating reserve).
If several through-beam photoelectric sensors which are installed next to one ano‐
ther are to be used, we recommend swapping the sender / receiver arrangement
at every second through-beam photoelectric sensor and ensuring that there is suf‐
ficient distance between the through-beam photoelectric sensors. By doing this,
mutual interference can be prevented [cf. F].
1