Stryker 240-099-155 Manual Del Usuario página 11

2. Place the monitor power supply in the cavity exposed by removal of the bottom shelf.
3. Connect the 5-pin connector on the monitor power supply to the 5-pin connector on the cable end.
4. Connect the monitor power supply to one of the hydra cable ends in the cavity.
5. Reinstall the bottom shelf and secure it with the 4 screws.
To install the monitor on the Connected OR Mount:
1. Secure the mounting bracket in the stow bracket on the cart to stabilize the arm.
2. Attach the monitor to the monitor mounting bracket using 4 M4x16mm screws.
Note: Ensure that all four screws are fully seated and the monitor is flush with the bracket. Ensure that there
is no gap between the monitor and the monitor mounting bracket.
P41610 Rev. C EN 9