Applying Grease To The O-Ring; Installing The O-Ring - Olympus UFL-2 Manual De Instrucciones

Applying grease to the O-ring

1 Apply the specified grease.
Spread the grease over
2
the O-ring.
Check that there is no
3 damage or irregularities
on the O-ring.
Apply the grease to the
4
O-ring contact surface.

Installing the O-ring

Confirm that no foreign matter is attached, apply a thin coat of the
accessory grease to the O-ring, and fit the O-ring into the groove. At this
time, confirm that the O-ring does not stick out from the groove.
CAUTION
• Always perform maintenance of the waterproof function even when the
battery cap has been opened to exchange the battery. Neglecting this
maintenance may result in water leakage.
• When the flash is not to be used for a long time, remove the O-ring from
the groove to prevent deformation of the O-ring, apply a thin coat of silicone
grease, and store it in a clean plastic bag.
• When drying is done with salt attached, it is likely that a function
impairment will be caused. After use, always wash off any salt.
Make sure there is no dirt on your fingers
or on the O-ring; then squeeze about 3
mm of grease onto your fingertip. (3 mm
is the most appropriate amount.)
Using two fingers and a thumb, spread
the grease over the O-ring while rubbing
it in. Use caution not to squeeze or pull
the O-ring too hard.
Once the grease
throughout the O-ring, check it for
damage or irregularities (both visually and
by touch). If you notice any abnormalities,
replace the O-ring with a new one.
Use any residual grease on your
fingertips to clean and lubricate the O-ring
contact surface on the battery cap.
EN
has permeated
EN 17