Appendix; Q & A On The Use Of The Ufl-2 - Olympus UFL-2 Manual De Instrucciones

9. Appendix

Q & A on the use of the UFL-2
Q1: What cautions must be observed when taking off the battery cap?
A1: Pay attention to the following points:
1 Take the cap off in a place where it is safe from spray and the
scattering of sand.
2 Wipe off all water drops in the gap between the battery cap and the
body, and any place that is uneven. As when taking off the cap water
drops may run inside.
3 Make sure there is no rubbish, hair or other foreign matter sticking
to the O-ring and O-ring contact surface (battery cap side).
4 Before returning the battery cap, make sure the O-ring is correctly
aligned with the O-ring groove.
5 Gently turn the battery cap. If it is turned too quick the O-ring may get
caught or not align correctly with the groove and may result in leakage.
Q2: What cautions must be observed when using and storing the flash?
1 When the flash is used, left or stored at the following locations,
A2:
defective operation or trouble may be caused. Always avoid such
locations:
• Places where the flash can reach high temperatures under direct
sunlight or in a car, places with extremely low temperatures, and
places with extreme temperature variations.
• Places with open fire
• Places with volatile substances
• Places with vibrations
2 The following instances could lead to operational problems and/or
damage to this flash. Avoid knocks and sudden increases in
pressure caused by:
• Hitting other objects
• Dropping
• Placing heavy objects on top of the flash
3 When the flash is not used for a long time, trouble from formation of
mold etc. may be caused. Before use, confirm the operation of all
operating parts and perform the O-ring maintenance.
See "2. Maintaining the Waterproof Function" (gP.15)
EN
EN 33