Basic Shooting; Turning On The Electronic Flash - Olympus UFL-2 Manual De Instrucciones

5. Basic Shooting

Turning on the electronic flash

Connect the flash to the camera's underwater case using a cable. After
turning on the camera and flash, be sure to check the remaining battery
power.
AUTO CHECK lamp
TEST button/
CHARGE lamp
1 Press the POWER button.
• The control panel is displayed and battery charging starts.
• Press the POWER button again to turn the electronic flash off.
2 Verify that the CHARGE lamp lights up.
• Replace the batteries if the time it takes for the CHARGE lamp to
light up exceeds the following values.
Alkaline or oxyride batteries
NiMH or lithium batteries
• If the CHARGE lamp and AUTO CHECK lamp blink simultaneously,
it means that the battery capacity is running low. In this case,
replace the batteries.
3 Press the TEST button to test the flash activation.
30 sec. or more
10 sec. or more
Control panel
POWER button
EN 23
EN