Advance Check Before Use; Remove The O-Ring - Olympus PPO-EP02 Manual De Instrucciones

2. Advance Check of the Lens Port

Advance check before use

This Lens Port has been the subject of thorough quality control for the
parts during the manufacturing process and thorough function inspections
during the assembly. In addition, a water pressure test is performed with
a water pressure tester for all products to confirm that the performance
conforms to the specifications.
However, depending on the carrying and storage conditions, the
maintenance status, etc., the waterproof function may be damaged.
Before using, always perform the following advance checks.
CAUTION:
If the advance test should show water leakage with normal handling, stop
using the Lens Port and contact your dealer or an Olympus service station.
Attaching/Removing the Rear Cap

Remove the O-ring

Remove the rear cap and remove the O-ring fitted to the Lens Port.
1 Insert the O-ring remover into the gap between the O-ring and O-ring
groove wall.
2 Slip the tip of the inserted O-ring remover below the O-ring.
(Be careful not to scratch the O-ring groove with the tip of the O-ring
remover.)
3 Lift the O-ring, pinch it with your fingertips and pull it out of the Lens
Port.
EN
EN 23