User Interface Setup - Kenwood DMX820WXS Manual De Instrucciones

Setting Up

User Interface Setup

You can setup user interface parameters.
1
Press the [MENU] button.
h Popup menu appears. h
2
Touch [SETUP].
h SETUP screen appears. h
3
Touch [User Interface].
h User Interface screen appears. h
4
Set each item as follows.
Beep
■
Turns the key touch tone on or off.
Default is "OFF".
Language
■
Selects a language.
Steering Remote Controller
■
Sets the desired function in the steering
remote controller. See Learning function of
steering remote (P.34).
Clock Adjust
■
Adjust the date and time manually. (P.7)
Ñ
Learning function of steering
remote
This function is available only when your vehicle
is equipped with the electrical steering remote
controller.
If your steering remote controller is not
compliant, learning may not be completed and
error message may appear.
1
Touch [Steering Remote Controller] in
the User Interface screen.
h Steering Remote Controller screen h
appears.
34
2
Touch the function you want to set.
NOTE
• You can have the unit learned all buttons at a
time. In that case, press the all buttons one at a
time and after pressing all of them, touch [
in Steering Remote Controller screen. However,
new functions cannot be learned after this
operation.
3
Press and hold the steering remote
controller button
4
Repeat steps 2 and 3 as necessary.
5
Touch [
].
NOTE
• When changing the function already learned,
select the function from the function list in step
2 and then press and hold the button you want
to change.
• Confirm the contents of the settable function on
the function list. You cannot edit the function
list.
• To initialize the contents, touch [Learning
initialisation] of [Steering Remote
Controller] in User Interface screen. After you
touch [Initialise], a confirmation message
appears. Follow the message and complete the
operation.
]