Kit Assembly - Metra 99-7360B Instrucciones De Instalación

ISO DIN radio provision
1. Mount the pocket to the brackets
with the (2) #8 x 3/8" Phillips
screws supplied. Note: Pins on
brackets will align with front
mounting hole of pocket.
(Figure A)
2. Slide the radio into the assembly
and secure with screws supplied
with the radio. (Figure B)
3. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and/or AXXESS.
4. Mount the new radio assembly into
the dash, snap the Metra radio trim
panel over the radio assembly, and
reassemble dash in reverse order
of disassembly.

Kit Assembly

(Figure A)
99-7360B
(Figure B)
3