ARIETE Vapori aspira Manual De Instrucciones página 35

It is also possible to use the attachment (Y) together with the
small brush (X), triangular brush (Z) or scraper (V) and other
attachments listed here above to obtain a combined dirt
removal-vacuum action.
The nozzle (U), nozzles (R and S), and brush (K) can all be fitted directly to the handle (A6) of the
nozzle (A) or to the extension tubes (C), following the steps described previously. They can also
be used to dispense steam evenly over the surfaces to be cleaned in order to dissolve dirt, which
can then be vacuumed up.
Suction+steam nozzle (O)
This attachment is recommended for medium-sized surfaces or to wash/vacuum or vacuum fab-
ric surfaces such as sofas, mattresses, etc., using the following frames (supplied):
• the glass wiper frame (P) is recommended for small mirrors, small windows, and cement glass
walls, etc.
• the bristled frame (Q) is recommended for rugs, stairs, car interiors, and fabric surfaces in gen-
eral; it is also useful for removing hairs from these surfaces.
To fit the required frame to the nozzle (O), it is sufficient to press it on until it clicks into place.
The nozzle can be connected to the steam nozzle (A) using one or both extension tubes (C), or it
can be fitted directly to the handle (A6).
To lock or release this attachment on the tubes or handle, it is necessary to turn the clip (B) after
inserting the attachment on the relevant coupling point.
The clip (B) must also be turned to fix the extension tubes in place.
Glass wiper (W)
The glass wiper (W) is ideal for large windows and mirrors as well as for smooth surfaces in gen-
eral.
The glass wiper can be connected to the nozzle (A) using one or both of the extension tubes (C),
or it can be inserted directly onto the handle (A6).
To lock or release this attachment on the tubes or handle, it is necessary to turn the clip (B) after
inserting the attachment on the relevant coupling point.
The clip (B) must also be turned to fix the extension tubes in place.
To use the glass wiper correctly, proceed as follows:
• Dispense steam evenly over the surface to be cleaned in order to dissolve the dirt.
• Press the rubber glass wiper against the surface to be cleaned, moving it vertically, from top to
bottom, with the vacuum function enabled.
CAUTION: When cleaning glass surfaces during particularly cold periods of the year,
pre-heat them by dispensing steam at an initial distance of 50 cm from the surface itself.
33