Publicidad
Step 3
Fasten the CABINET RAILS (GG and HH) to the LEFT END (B) and LEFT UPRIGHT (D). Use four GOLD 5/16" FLAT
å
HEAD SCREWS (PPP).
NOTE: The CABINET RAILS are marked "CABINET RIGHT" and "CABINET LEFT" for easy identifi cation.
å
Separate the NARROW EXTENSION SLIDES (BB) from the NARROW EXTENSION RAILS (AA) as shown in the upper
å
diagram below. Be prepared, the parts are greasy.
Fasten the NARROW EXTENSION RAILS (AA) to the LEFT END (B) and LEFT UPRIGHT (D). Use four GOLD 5/16" FLAT
å
HEAD SCREWS (PPP).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
å
of the EXTENSION RAIL out to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
Roller end
Page 8
BB
Push the release lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
HH
AA
Open end
Finished edge
AA
PPP
(8 used in this step)
GG
Narrow
B
404944
Roller end
Open end
Finished edge
AA
D
www.sauder.com/services
Publicidad
