American Standard Delancey 7052207 Instrucciones De Instalación página 2

2
INSTALL DRAIN FROM BELOW FIXTURE
DRAIN
OUTLET
1
• Install DRAIN (1) by dropping it from the top of the sink.
• From under side of SINK install GASKET (2) and
MOUNTING NUT (3).
Note: Plumber's putty or caulk is recommended.
4
FLANGE GASKET AND POP-UP KNOB
FOAM
GASKET
NOT VISIBLE
• Check DRAIN FLANGE in SINK to ensure that
FOAM GASKET is fully compressed and not visible.
6
MAKE WATER SUPPLY AND WASTE CONNECTIONS
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE
PURCHASED SEPARATELY.
• Connect water supply to FAUCET (1) with 1/2" IPS FLEXIBLE
SUPPLIES (2) or 3/8" O.D. BULL-NOSE RISERS (3).
• Use adjustable wrench to tighten connections. Do not over
tighten. Be careful not to kink copper supply when bending.
Use tubing cutter to cut to proper length.
• Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to
waste outlet.
REAR OF SINK
2
3
DRAIN
FLANGE
3
• Thread TAIL PIECE NUT (1) clockwise onto
DRAIN BODY (2).
5
CHECK OPERATION OF POP-UP
• Operate DRAIN STOPPER (1) to verify that it opens
and closes.
1/2" PIPE
THREAD
2
FLEXIBLE
SUPPLIES
3/8" COMPRESSION
CONNECTION
HOT
- 2 -
2
1
1
1
COUPLING
NUT
3
3/8 O.D.
BULL-NOSE
RISERS
COMPRESSION
NUT
FERRULE
COLD
M965986 1.0 (5/19)