7
TEST INSTALLED FITTING
• With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
• Remove AERATOR (3).
• Operate both HANDLES (1) to flush water lines thoroughly.
• Replace AERATOR (3).
CHECK DRAIN CONNECTIONS
• Fill lavatory with water. Check that DRAIN STOPPER (4)
makes a good seal and retains water in SINK.
• Check all drain connections and "P" trap for leaks.
Tighten if necessary.
8
SERVICE
CAUTION
If Faucet Drips, Proceed As Follows:
• Turn HANDLES (1) to OFF position.
• If spout drips, operate HANDLES (1) several times from OFF
to ON position. Do not force HANDLES they turn only 90˚.
• AERATOR (2) may accumulate dirt causing distorted and
reduced water flow. Remove AERATOR 2) and clean
before reinstalling.
9
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
Turn off hot and cold water
supplies before begining.
1
WASTE
OUTLET
2
1
- 3 -
3
1
4
2
"P" TRAP
2
M965986 1.0 (5/19)