Set Up General; Initial Inspection; Operating Checks - Textron JACOBSEN InCommand Eclipse 2 118 Manual Del Distribuidor

3 SET UP
3 SET UP
3.1 GENERAL________________________________________________________________
The set-up and testing of the unit should always be
performed by a trained technician, familiar with the
operation of the equipment.
Read each instruction completely and make sure you
understand it before proceeding with the assembly. Stay
alert for potential hazards and obey all safety
precautions.
The RIGHT, LEFT, FRONT and REAR of the machine are
referenced from the operator's seat, facing forward.
3.2

INITIAL INSPECTION_______________________________________________________

The initial inspection should be performed only when the engine is off and all fluids are cold.
1. Perform a visual inspection of the entire unit, look for
signs of wear, loose hardware, and components that
may have been damaged during transport.
2. Inspect paint and decals for damage or scratches.
Decals provide important operating and safety
information. Replace all missing or hard to read
decals.
3.3

OPERATING CHECKS______________________________________________________

After the initial inspection, test the machine for proper
operation.
1. Test the Operator Presence Control. (Section 4.4)
2. Start the machine and check that controls operate
as described. (Section 3.2)
3. After operation, stop and inspect again for fuel or oil
leaks.
20
!
Disengage all drives, engage parking brake, and stop engine.
Accessories not included with this product must be
ordered separately. See instructions provided with
accessory for installation and parts.
Do not attempt to operate the machine unless
you are familiar with this type of equipment and
know how to operate all controls correctly.
This machine is shipped assembled. After unpacking,
perform the initial inspection, operating checks, and test
the Operator Presence Control (OPC).
CAUTION
3. Check that the engine oil level is at the full level
mark with the engine cold.
4. Visually check for fuel or oil leaks.
5. Inspect lube points for proper lubrication.
!
CAUTION