Engine Oil Change; Engine Speed - Textron JACOBSEN InCommand Eclipse 2 118 Manual Del Distribuidor

5 GAS ENGINE POWER MODULE SET UP
5.3

ENGINE OIL CHANGE ______________________________________________________

Perform initial oil change after the first 20 hours of
operation. Change oil every 100 hours thereafter.
1. To change engine oil, attach a 7/16 in. (11 mm) i.d.
hose (A) to oil drain valve (B). Place other end of
hose into a suitable container.
2. Remove oil fill plug (C).
3. Push drain lever (D) towards rear of mower and
rotate down. Allow engine oil to drain into container.
4. When oil has completely drained, rotate drain lever
(D) up until it latches in the closed position.
5. Remove hose (A) and clean up any spilled oil.
6. Add engine oil until oil level is at full level. See
Figure 5A.
After adding or changing oil, start and run engine at idle
with all drives disengaged for 30 seconds. Shut engine
off. Wait 30 seconds and check oil level. Add oil to bring
up to FULL level.
5.4

ENGINE SPEED ___________________________________________________________

The engine speed is set at the factory for proper
generator output. However, engine speed should be
checked periodically, and adjusted to 59.8 volts. An
output voltage greater than 60 volts will cause system
damage.
Adjustment should be made with the engine at operating
temperature using a volt meter.
1. Stop the engine and disconnect the generator power
connector.
2. Remove the throttle lever cover.
3. Start the engine and adjust the engine throttle
position until an output voltage of 59.8 volts is
achieved at generator power connector.
4. Stop the engine and install throttle lever cover.
5. Connect generator power connector.
28
Use only SAE 10W30 engine oils with API classification
SG.SF/CC.CD.
D
C
B
A
Figure 5B