Cequent Performance Products 30095 Instrucciones De Instalación página 11

94-01 DODGE 1500 & 94-02 DODGE 2500, 3500
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck.
Front of Vehicle
Fifth wheel hitches over
18k must have a center
bolt the center hole in both
rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolts and hardware
are supplied with Fifth
wheel or gooseneck
hitches that are rated over
18k.
Front
of
Vehicle
See following page
for carriage bolt (9)
installation
instructions.
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Cequent Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately
30095N 6/13/14 REV. K
Instructions continued on the next page.
Axle Center
Note: Pull wire provided, may be needed to install
hardware in brackets through frame.
CAUTION!
the responsibility of the installer to prevent damage due to installation.
©2014 Cequent Performance Products, Inc.
LONG BED AND SHORT BED
CAUTION!
King Pin Center approx.
Over Axle Center
Rear Edge of
Truck Bed
28-7/16" Long Bed
24-5/16" Short Bed
Measure from Rear Edge of
truck bed to rear edge of
base rail.
Bed Sill
Drivers side Ram 1500 Shown
Angled
bracket
*
1/4 2
*
1/4 2
PRINTED IN CHINA
Optional
weld
pattern
11