Publicidad
Idiomas disponibles
Idiomas disponibles
Chevy & GMC '00 to 10 Silverado, Sierra including HD models, and '04 & up 1500 Crew
Cab with 5'8" bed (Reese
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1.
Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the approximately 4" between
parallel rows of spot welds where the bed sill sets.
Front of
Vehicle
Fifth wheel hitches over
18k must have a center
bolt in the center hole in
both rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolts and hardware
are supplied with Fifth
wheel or gooseneck
hitches that are rated over
18k.
* Optional weld
pattern
Front of
Vehicle
Straight Bracket
1/4
1.5-3
*
1/4
2
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc. Cequent
Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the responsibility of the
30095N 6/13/14 REV. K
GM '99 Silverado, Sierra (not Sierra Classic) models
King Pin Center approx.. 3-1/2"
forward of Axle Center
Note: Pull wire provided, will be needed to install
hardware in brackets through frame.
installer to prevent damage due to installation.
©2014 Cequent Performance Products, Inc.
™
Pinbox required for 5'8" bed)
®
Sidewinder
CAUTION!
Center
Hole
Center
Hole
CAUTION!
Rear Edge of
Truck Bed
Long Bed =31"
Short Bed =23 1/2"
Measure from rear edge of
truck bed to rear edge of
base rail
Axle Center
Left, right angle and frame
brackets may be placed
wherever brackets fits best.
Bed Sill
Angled Bracket
PRINTED IN CHINA
Drivers side of 3/4 ton
Chevy Long Box Shown
5
Publicidad
