Cequent Performance Products 30095 Instrucciones De Instalación página 14

2005-CURRENT FORD F-250, F-350 & F-450 SUPER DUTY (NOT CAB-CHASSIS)
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the approximately 4" between
parallel rows of spot welds where the bed sill sets.
2. It may be necessary to move the brake cable hanger bracket into another hole just rearward from its present
location.
Front of Vehicle
Fifth wheel hitches over
18k must have a center
bolt in the center hole in
both rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolts and hardware
are supplied with Fifth
wheel or gooseneck
hitches that are rated over
18k.
Hitch center approximately
Over the axle center.
Front of
Vehicle
* Optional weld pattern. Typical for all 4
brackets.
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc. Cequent
Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately the responsibility of the
30095N 6/13/14 REV. K
Angled Bracket
Straight Bracket
DRIVERS SIDE
Bed sill
Note: Pull wire provided, will be needed to install
hardware in brackets through frame.
installer to prevent damage due to installation.
©2014 Cequent Performance Products, Inc.
CAUTION!
Measure from Rear Edge of
truck bed to rear edge of base
rail.
Angled Bracket
CAUTION!
Straight Bracket
Rear Edge of
Truck Bed
30 3/16" Long Bed
& Short Bed
PASSENGERS SIDE
Bed sill
1/4 2
*
1/4 2
F-350 super Duty long bed
frame shown
PRINTED IN CHINA
Front of
Vehicle
14