Pull Wire - Cequent Performance Products 30095 Instrucciones De Instalación

2014-CURRENT RAM 2500 (REQUIRES 58522 BRACKET KIT)
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Rib neck bolts will need to be pulled through rearward access holes in frame with supplied pull wire.
2. Do not drill thru both walls
of frame. Drill only thru
wall of frame to which
bracket is mounted.
3. Forward brackets can be
mounted to the frame in
the existing threaded
holes using a conical
washer and the M12
40mm Bolts supplied.
Torque to 92 Ft.-Lbs.
4. *Due to tubular frames
having thinner walls than
previous C channel
frames, extra caution
needs to be used when
mounting with the
optional welding.
Front of
Vehicle
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CEQUENT PERFORMANCE PRODUCTS does its best to communicate tow vehicle manufacturer changes; however, it is
ultimately the responsibility of the installer to prevent damage due to installation.
30095N 6/13/14 REV. K
Side Bracket
Inside Frame
©2014 Cequent Performance Products, Inc.
CAUTION!
King Pin & Axle
Center
Bed Sills
CAUTION!
Fifth wheel hitches over 18k
must have a center bolt in
the center hole in both rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolt and hardware
are supplied with fifth wheel
or gooseneck hitches that
are rated over 18k.
Rear Edge
of Truck Bed
25 11/16" Long Box
23 3/4" Short Box
Measure from
Rear Edge of
truck bed to rear
edge of base rail.
Straight Bracket
(Inside Frame)
Driver side of Ram 2500
*
Optional
1/4 1.5-3
*
1/4 2
pattern
PRINTED IN CHINA
weld
8