Cequent Performance Products 30095 Instrucciones De Instalación página 17

2000-06, TOYOTA TUNDRA (STANDARD CAB LONG BED ONLY)
Read pages 1-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the approximately 4" between
parallel rows of spot welds where the bed sill sets.
2000-06, TOYOTA TUNDRA long: (Approx. over the axle)
With Fifth wheel assembly in the bed of the truck. Position the rear rail 30 7/16" from rear edge of truck bed. Attach the left and right
angled frame brackets to the rear Fifth wheel rail. Note: The left and right angle bracket can be mounted on either side of the truck if
needed. Then attach the frame bracket to the front Fifth wheel rail.
Front of Vehicle
Fifth wheel hitches over
18k must have a center
bolt in the center hole in
both rails.
Note: Place center bolt in
the hole that does not
interfere with the bed sill. If
needed, flip the rail around.
Center bolts and hardware
are supplied with Fifth
wheel or gooseneck
hitches that are rated over
18k.
King Pin Centered approx. 1-1/4"
forward of Axle Center
Straight bracket
1/4 1.5-3
*
1/4 2
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
Cequent Performance Products, Inc. does its best to communicate tow vehicle manufacturer changes; however, it is ultimately
30095N 6/13/14 REV. K
Note: Pull wire provided, will be needed to install
hardware in brackets through frame.
CAUTION!
the responsibility of the installer to prevent damage due to installation.
©2014 Cequent Performance Products, Inc.
CAUTION!
Axle Center
Rear Edge of
Truck Bed
30 7/16"
Measure from Rear Edge of
truck bed to rear edge of
base rail.
Left, right angle and frame
brackets maybe place where
ever brackets fits best.
Drivers side shown
Angled bracket
1/4 2
*
1/4 2
* Optional weld pattern
PRINTED IN CHINA
17