Filling The Rinse Aid Dispenser; Rinse Aid Setting - Haier HDBC100AFS Manual Del Usuario

FILLING THE RINSE AID DISPENSER

The rinse aid dispenser holds 3.4 oz ( 100 ml) of rinse aid. Under normal conditions,
this will last for about three months. Rinse aid is released through an opening in the
dispenser. You do not need to wait until the dispenser is empty to refill it. Try to keep
it full, but be careful not to overfill it.
To fill the rinse aid dispenser:
1. Make sure the dishwasher door is fully open.
2. Turn the rinse aid dispenser cap counterclockwise and pull up to remove.
c
3. Pour rinse aid into the dispenser until just full.
4. Clean up any spilled rinse aid with a damp cloth.
5. Replace the rinse aid cap, and then turn the cap clockwise to close.

RINSE AID SETTING

The amount of rinse aid released into the final wash can be adjusted. The factory
setting is at 2. For most water conditions, set the adjuster to 2 or 3. If there are rings
or calcium ( hard water ) spots on dishes, try a higher setting.
To adjust the setting:
Remove the dispenser cap. Turn the adjuster inside the dispenser to the desired setting.
a
b
a
a
a
Fill Indicator
b
Adjustable Setting
c
Dispenser Cap
Adjustable Setting
13