Jigsaw Safety Warnings - SPARKY FSPE 110 Instrucciones De Uso

c) Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any ad-
justments, changing accessories, or
storing power tools. Such preventive
safety measures reduce the risk of start-
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other con-
dition that may affect the power tool's
operation. If damaged, have the power
tool repaired before use. Many acci-
dents are caused by poorly maintained
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
5) Service
a) Have your power tool serviced by a
identical replacement parts. This will
ensure that the safety of the power tool is
Jigsaw safety
warnings
Wear hearing protection during con-
tinuous operation. Intense noise loading
during operation may damage the operator's
During operation provide eye protec-
ing particles. Wear goggles.
Take protective measures against in-
halation of dust. Some materials can con-
tain toxic ingredients. Wear a dust mask
Original instructions
Hold the power tool by insulated grip-
ping surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of the
power tool "live" and could give the operator
tos. Asbestos is considered carcinogenic.
WARNING: Before connecting a tool
to a power source be sure that the voltage
nameplate of the tool.
ous injury to the user, as well as damage to
the tool.
than the nameplate rating is harmful to the
motor.
potential overheating.
must ensure that it has the right ampere rat-
ing for your power tool and it is in safe elec-
trical condition.
WARNING: Always switch off and
un-plug the power tool prior to any adjust-
ment, servicing or maintenance or in case of
mains drop-out.
whenever possible.
cure stance. The power tool is guided more
securely with both hands.
set properly in its place.
not reach under the workpiece. Contact with
the saw blade can lead to injuries.
-
when switched on.
chine off and then pull the saw blade out of
the cut only after it has come to a standstill.
on the material while sawing.
-
-
-
-
5 EN