Electrical & Gas Supply Requirements - Haier HLTD600AEW Manual Para El Usuario

ELECTRICAL & GAS SUPPLY REQUIREMENTS
GROUNDING INSTRUCTIONS:
This appliance must be grounded. In the event of malfunction or
breakdown, grounding will reduce the risk of electric shock by providing a
path of least resistance for electric current. This appliance is equipped with
a cord having an equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is properly installed
and grounded in accordance with all local codes and ordinances.
Improper connection of the equipment grounding conductor can result
in a risk of electric shock. Check with a quali ed electrician or service
representative or personnel if in doubt as to whether the appliance is
properly grounded.
ELECTRIC DRYER (U.S. ONLY)
Improper connection of the equipment-grounding conductor can result
in a risk of electric shock. Check with a quali ed electrician or
serviceman if you are in doubt as to whether the appliance is properly
grounded.
NOTE: The electrical supply for the dryer must conform with local codes and
ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70.
•
If the electrical supply available in the intended dryer location does not meet the
above requirements, contact a licensed electrician.
•
A dryer operating on a 208 volt power supply will have longer drying times than if
it were operating on a 240 volt power supply.
•
The dryer is not equipped with a power cord. A kit that meets local electrical
codes must be purchased separately. The dryer can be fitted with a 3 or
4-wire NEMA 14-30 or 10-30 type SRDT or ST (as required) power cord rated
at 120/240 volt AC minimum, 30 amp, with 3 open-end spade lug connectors
with upturned ends or closed loop connectors and marked for use with clothes
dryers.
•
A UL listed strain relief must be attached to the dryer to hold the power cord.
•
Do not use an aluminum wire receptacle with copper-wired power cord and plug
(or vice versa). The proper wiring and receptacle is a copper-wired power cord
with a copper-wired receptacle.
•
The electrical outlet should be located so that the power cord is accessible when
the dryer is in the installed position.
10
WARNING
WARNING