Gas Dryer - Haier HLTD600AEW Manual Para El Usuario

ELECTRIC DRYER (CANADA ONLY)
The dryer must be plugged into a properly grounded 4-wire, single
phase, 120/240 volt, 60Hz, AC-only electrical outlet connected to an
individual 30-amp circuit, fused with a 30-amp time-delay fuse or
circuit breaker. Do not operate a washer and dryer on the same circuit.
NOTE: The electrical service to the dryer must conform with local codes and
ordinances and the latest edition of the CSA C22.1 Canadian Electrical Code Part 1.
•
If the electrical supply available in the intended dryer location does not meet the
above requirements, contact a licensed electrician.
•
All Canadian models are shipped with the power cord attached. The power cord
should be plugged into a 30-ampere receptacle. In Canada, you may not convert
a dryer to 208 volts.
•
The electrical outlet should be located so that the power cord is accessible when
the dryer is in the installed position.

GAS DRYER

ELECTRICAL SUPPLY REQUIREMENTS
The gas dryer must be plugged into a properly grounded 3-wire, single
phase, 120 volt, 60Hz, AC-only electrical outlet, fused with a 15-amp
time-delay fuse or circuit breaker.
•
The dryer is equipped with a power cord that has a 3 prong plug. Do not cut or
remove the grounding prong from the power cord.
•
The power cord must be plugged into a mating, 3 prong outlet, grounded in
accordance with local codes and ordinances. If a mating outlet is not available,
contacted a licensed electrician to have one installed.
•
If you are not sure if your outlet is properly grounded, contact a licensed
electrician.
•
Do not use a 3 prong plug adapter.
•
Do not use an extension cord.
WARNING
WARNING
11