Electrolux EIV85443 Manual De Instrucciones página 22

Problem
Automatic Heat Up does not op‐
erate.
The heat setting changes be‐
tween two levels.
The sensor fields become hot.
There is no sound when you
touch the panel sensor fields.
The flexible induction cooking
area does not heat up the cook‐
ware.
comes on.
comes on.
and a number come on.
You can hear a constant beep
noise.
22 ENGLISH
Possible cause
The zone is hot.
The highest heat setting is set.
Power management operates.
The cookware is too large or you put
it too near to the controls.
The sounds are deactivated.
The cookware is in a wrong position
on the flexible induction cooking
area.
The diameter of the bottom of the
cookware is incorrect for the activa‐
ted function or function mode.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
FlexiBridge (Flexible Bridge) oper‐
ates. One or more sections of the
function mode which operates are
not covered by the cookware.
PowerSlide operates. Two pots are
placed on the flexible induction
cooking area.
There is an error in the hob.
The electrical connection is incor‐
rect.
Remedy
Let the zone become sufficiently cool.
The highest heat setting has the same
power as the function.
Refer to "Daily use".
Put large cookware on the rear zones,
if possible.
Activate the sounds. Refer to "Daily
use".
Place the cookware in the correct posi‐
tion on the flexible induction cooking
area. The position of the cookware de‐
pends on the activated function or
function mode. Refer to "Flexible in‐
duction cooking area".
Use cookware with a diameter applica‐
ble to the activated function or function
mode. Refer to "Flexible induction
cooking area".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer to "Hints
and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Place the cookware on the correct
number of sections of the function
mode which operates or change the
function mode. Refer to "Flexible in‐
duction cooking area".
Use only one pot. Refer to "Flexible in‐
duction cooking area".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
comes