Safety Instructions - cecotec BAKE&STEAM 3000 COMBI Manual De Instrucciones

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
All safety instructions should be closely followed when using
the appliance.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the outlet is
grounded.
Do not immerse the cord, plug, or any non-removable part
of the product in water or any other liquid. Do not expose the
electrical connections to water. Make sure your hands are dry
before handling the plug or switching on the appliance.
Do not unplug the device when it is being used.
If the product falls accidentally in water, unplug it immediately.
Do not reach into the water!
Check the power cord regularly for visible damage. No user-
serviceable parts inside. If the cord is damaged, it must be
replaced by the official Technical Support Service of Cecotec, in
order to avoid any type of danger.
Do not use the appliance if its cord, plug, or housing is damaged,
nor after it malfunctions or has been dropped or damaged in
any way.
Do not twist, bend, strain, or damage the power cord in any
way. Protect it from sharp edges and heat sources. Do not let
it touch hot surfaces. Do not let the power cord hang over the
edge of table or countertop.
Pull from the plug, not the cord, to disconnect it from the outlet.
This appliance is intended for home use only. Any other use will
void the warranty. It is not suitable for commercial or industrial
use. Do not use it outdoors.
Place the appliance on a dry, stable, flat, heat-resistant surface.
Do not use the appliance under the following circumstances:
On or near a gas or electric hob, in heated ovens, or near open
flames.
On soft surfaces (such as carpets) or where it may tip over
during use.
Outdoors or in areas with high humidity levels.
The temperature of accessible surfaces may be high while in
use and could cause burns. Do not touch hot surfaces while in
use or immediately after. Use handles or gloves.
Allow a 10 cm distance from the device's sides, back
and top to the walls or other objects. Do not cover the
appliance while in use.
Do not leave the appliance unattended while in use.
Steam at high temperature will be released when the device's
door is opened during and after the cooling process of the
product. A safe distance shall be kept in order to avoid scalding.
Ensure that the appliance is switched off before replacing the
lamp to avoid the possibility of electric shock.
Do not overfill the water tank, do not exceed the MAX. mark.
Do not share an outlet with other high-power electrical devices
to avoid the risk of fire caused by a circuit overload.
The appliance is not intended to be operated by means of an
external timer or separate remote-control system.
Do not use any accessory that has not been recommended by
the manufacturer, as they might cause injuries or damage.
Extreme caution must be used when moving an appliance
containing hot oil or other hot substances.
Allow the appliance to cool down before disassembling or
assembling the device.
Unplug it from the mains supply when you finish using it or