Cleaning And Maintenance - cecotec BAKE&STEAM 3000 COMBI Manual De Instrucciones

ENGLISH
F-31 Yoghurt 480
Note: These data are approximate and will depend on different factors.

4. CLEANING AND MAINTENANCE

Take off the plug and cool down before cleaning.
When cleaning, wash the interior and exterior with soft cotton (or sponge) with neutral
cleaner.
Then wash with clean water. Do not use hard brush or any others to wash, so as not to
scrape the interior surface of the oven.
Do not use toxic and abrasive cleaners such as gasoline, polishing powder or solvent.
The water tank shall be cleaned and wiped gently with a soft cloth. After wiping or cleaning
the inner wall, install the water tank in its original place.
After cooking is completed, empty the residual water in the water holder.
The sealing surface of the oven door shall be cleaned frequently and wiped with a soft dry
cloth.
The grill is dishwasher safe.
If the steam oven is not going to be used for a long time, disconnect it from the power supply
and clean the cavity.
Unplug the device when replacing the bulb.
Store the device in a safe, dry place.
5. TROUBLESHOOTING
Error Possible cause
E01 Back temperature sensor
error
E02 Back temperature sensor
short-circuit
E03 Top temperature sensor error
52
BAKE&STEAM 3000 COMBI
45
Solution
Turn the oven off, open the door and
allow it to cool down for 10 minutes.
If the problem continues, contact the
Technical Support Service of Cecotec.
Turn the oven off, open the door and
allow it to cool down for 10 minutes.
If the problem continues, contact the
Technical Support Service of Cecotec.
Turn the oven off, open the door and
allow it to cool down for 10 minutes.
If the problem continues, contact the
Technical Support Service of Cecotec.
E04 Top temperature sensor
short-circuit
E05 Top steamer sensor error
E06 Top steamer sensor short-
circuit
The display The device is not connected
does not turn properly to the power supply.
on
The inside light The bulb is damaged.
does not turn Poor contact.
on
The fan does Poor contact.
not work Fan is damaged.
No response The PCB is damaged.
from buttons The display is damaged.
No steam The water pipe is blocked.
The device is faulty.
The water intake system is
damaged.
The device does The door is not closed
not work properly.
The door contact or sealing is
damaged.
Steam leakage The door is not closed
from the oven properly.
door The door contact or sealing is
damaged.
There is too much steam
inside the oven. This is
normal.
ENGLISH
Turn the oven off, open the door and
allow it to cool down for 10 minutes.
If the problem continues, contact the
Technical Support Service of Cecotec.
Contact the Technical Support Service
of Cecotec.
Contact the Technical Support Service
of Cecotec.
Disconnect and connect it again.
Replace the bulb.
Contact the Technical Support Service
of Cecotec.
Contact the Technical Support Service
of Cecotec.
Contact the Technical Support Service
of Cecotec.
Contact the Technical Support Service.
Close the door properly.
Make sure the tank is full and properly
installed.
Contact the Technical Support Service
of Cecotec.
Close the door properly.
Contact the Technical Support Service
of Cecotec.
53
BAKE&STEAM 3000 COMBI