Placing Your Child In The Thunder Car Seat; Detaching The Seat; Adjusting The Height Of The Shoulder Belts - Be Cool thunder iso-fix Manual De Instrucciones

EN
PLACING YOUR CHILD
IN THE THUNDER CAR SEAT
Loosen the shoulder belts by pressing the realease button and
pull the shoulder belts towards you.
Important: Do not pull on the belt pads when doing so. (Fig. 8-9)
Press the red button to open the buckle. (Fig. 10)
Part the belts over the sides of the shell. (Fig. 11)
Place your child into the shell and make sure that there are no
toys or other hard objects in the shell. (Fig. 12)
Match buckle tongue sections together and insert them into the
buckle. (Fig. 13)
f) Make sure the shoulder belts fit your child snugly by pulling the
adjuster belt. (Fig. 14)
Note! After you have done the installation, check it by trying to
move it, it shouldn't move more than an inch side along the belt
path, if it does, tightens the straps or try installing it again.
The belts should never be twisted. If you are unable to click the
tongue sections into the buckle, unlock the buckle by pressing the
red button and try again.

DETACHING THE SEAT

To detach the seat follow the installation instructions in reverse. (it
is advisable to give yourself a bit more space by moving the front
seat forward as far as possible)
- First unfasten the headrest anchor (TOP TETHER). F7
20
- Then unfasten the ISO-FIX, get inside the vehicle facing the
IM-1613,04 THUNDER ISOFIX inst OK.indd 20
Thunder safety seat, then simultaneously raise the catches
found on both sides and gently pull outwards, until uncovering
the buttons on each side of the isofix leg that display the status:
GREEN (connected) or RED (disconnected), press the green
button and pull the seat and the ISO-FIX anchor will be discon
nected, and then the seat is released. F7.a - F7.b - F7.c
ADJUSTING THE HEIGHT
OF THE SHOULDER BELTS
a) The correct height of the shoulder belts is attained when the
belt disappears into the shell slightly above the shoulder of
the child. Ensure that the shoulder belts fit comfortably over
the child's shoulder. (Fig. 15)
b) Loosen the shoulder belts by pressing the release button of
the adjuster and pulling the shoulder belts towards you as far
as possible.
Important: Do not pull the belt pads when doing so. (Fig. 9)
c) Place the shell of the seat in the sleeping position.
d) Remove the shoulder belts from the yoke. (Fig. 16-a)
e) Pull the shoulder belts through the belt pads and belting slots
in shell, ensuring that the buckle remains fixed to prevent the
belts being twisted. (Fig. 17)
f) If you want to alter the belts from or to the lowest positions,
place the THUNDER to the sleeping position.
g) If you want to alter the belts from or to the higher positions,
place the THUNDER to the sitting position.
h) Place the shoulder pads at the expected height and thread the
20/6/18 10:51