Siemens SIMATIC PC BI45 Ficha Del Producto página 9

1.3.1 FCC Approval for USA and Canada
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Shielded cables must be used with this equipment to maintain compliance with FCC
regulations.
Changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment does not exceed the Class A limits for radiated emissions as described
in the Radio Interference Regulations of the Canadian Department of
Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les
limites applicables aux appareils numériques de la Classe A prescrites dans le
Réglement sur le brouillage radioélectrique édicté par le Ministère des
Communications du Canada.
Ficha del producto PC BI45/FI45 PII
C79000-Z7078-C795-03
Federal Communications Commission
Radio Frequency Interference Statement
Shielded Cables
Modifications
Conditions of Operations
Canadian Notice
Avis Canadien
9