Mutsy EVO Manual De Instrucciones página 29

seat is standing upright.
· Push the buttons on both sides of the push bar and turn the push bar
downwards until it has reached its lowest position.
· This position is indicated by means of a marking on the hinge point.
· Pull the unlock buttons on the inside of the frame towards you and
then push the top part of the frame downwards.
· Pull the button at the back of the seat upwards, hold this upwards and
tilt the back support of the seat backwards until it is fully flat.
· Push the buttons on both sides of the leg support and push the leg
support fully downwards.
Adjust the back support (s)
· Pull the button at the back of the seat upwards and hold it upwards.
· The back support has 4 positions. Place the back support in the desired
position and release the button to lock the position.
Adjust the leg support (t)
· Lift the leg support to place it upwards.
· Push the buttons on both sides of the leg support and push the leg
support downwards to lower it.
Attach and remove bumper bar (t)
· Push the ends of the bumper bar in the thereto designated notches in
the seat until you hear a click.
· Press the unlock buttons on both sides of the bumper bar and remove
the bumper bar from the seat.
The integrated foot step (v)
· There is a zipper around the leg support of the seat. If so desired you
can open this zipper to thus create a higher foot rest for your child.
The child can then place the feet on the aluminium bar of the leg
support. When your child gets bigger you can again close the zip-
per and your child can place the feet on the plastic foot rest of the
frame.
The hood (u1, u2)
· Hold the front hood bar in the centre and move it forwards or rear-
wards to adjust the hood. (u1)
· Open the zipper in the centre to further enlarge the hood. Close the
zipper to again reduce the hood. (u2)
· Pull the flap on the front side of the hood outwards to additionally en-
large the hood. Push the flap inwards to again reduce the hood.
EN
23