The Safe2Go Car Seat - Mutsy EVO Manual De Instrucciones

Ocultar thumbs Ver también para EVO:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
Assemble the rain cover on the seat (w)
· Make sure that the hood of the seat is in the upright position.
· Possibly open the zipper in the rain cover to adapt it to the enlarged
hood of the seat.
· Place the rain cover from top to bottom over the seat and make sure
that the rain cover is attached well behind the back support and over
the leg support.
The 5-point safety harness (x, y)
· Place your child in the seat and make sure that the legs of your child
are placed on each side of the leg piece.
· Make sure that the hip and shoulder belt is positioned correctly over
your child and place both plastic clamps in the central part of the har-
ness attached to the leg piece.
· To adjust the length of the shoulder straps, loosen the shoulder pro-
tectors from the belt by undoing the snap buttons. This will reveal
the belt buckles. Adjust the length by sliding the buckles along both
shoulder straps until your child is comfortably secure. After adjust-
ing, press down both snap buttons to relock the shoulder protectors
in place.
· The back support contains three positions for the shoulder belts. To
adjust the position you remove both shoulder belts by moving the
attachment rings through the openings in the back of the seat. Move
the attachment rings through the desired openings so that the shoul-
der belts are positioned properly.
· Regularly check the length and position of the belts and adjust, where
necessary.
· If the waist or crotch strap needs to be reassembled move the attach-
ment ring through the corresponding opening.
Safe2go car seat (up to 13 kg)
· Make sure that the frame has fully been unfolded and the brake blocked
during all actions indicated below.
Place the Safe2go adapters on the frame
· There are two foldable attachment points on both sides of the
frame. Make sure that the attachment points are in a vertical posi-
tion.
· The adapter marked with 'R' is placed on the right side of the frame,
the adapter marked 'L' is placed on the left side.
· Slide the adapters in the attachment parts and press solidly until
you hear a click.
24

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Evo2

Tabla de contenido