3�1 Grinding Angle Adjustment; Adjust The Water Flowrate - Renfert MT3 Instrucciones Para El Servicio

Ocultar thumbs Ver también para MT3:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
2.3
Electrical connection
• Ensure the mains supply and voltage marked on the nameplate is identical�
• Plug in at the mains (7, Fig� 1, 2)�
2.4
Switching on / off
MT3:
Switch the appliance on and off by the On/Off switch (2, Fig� 1)�
MT3 pro:
If the operating screen is damaged or defect in any way, please remove the device from operation and send in
for repair.
Switch the appliance on and off by the On/Off switch (2, Fig� 2)�
The blue LED (3, Fig� 2) remains illuminated when the appliance is in operation�
EN
After switching on, wait until the trimmer disc has reached the rated speed (approx 2 - 3 seconds).
Start trimming only then.
3.
Operation
3.1
Grinding Angle Adjustment
3.1.1 MT3
• Turn off appliance and wait, until the trimmer disk comes to an complete standstill�
• Pull grinding table (5) at leading edge upward from ball head�
• Turn bracket (21) to desired position�
- long axle stub: 90°
- short axle stub: 98°
• Press grinding table back onto ball head�
3.1.2 MT3 pro
• Turn off appliance and wait, until the trimmer disk comes to an complete standstill�
• Loosen the knurled nut (20)�
• Adjust the grinding angle with the adjusting screw (19)�
• Retighten the knurled nut (20)�
The 90° position is roughly adjusted, when the marking of the grinding table alignes with
the top edge of the grinding table holder (Fig� 6a)�
The fine adjustment ist done with the angle bracket (10, Fig. 2).
The angle bracke can be stored away at the back of the appliance�
3.2

Adjust the water flowrate

• Open water supply shutoff tap�
• Turn on appliance�
• Adjust water flow rate at water inlet (14).
3.3
Trimming
• If necessary check and adjust the grinding angle�
• Turn on appliance�
• Wait until rated speed is reached (approx 2 - 3 seconds)�
• If necessary readjust the water flow rate.
• Using both hands, securely set the model on the grinding table and press it against the
disc�
Once the work has been finished:
• Switch off the appliance�
The water supply shutoff tap should be closed when work is interupted for longer
periods and when the appliance is unattended (e.g. over
EN
night).
- 4 -
5
90°
98°
21
Fig� 5
Fig� 6a
20
Fig� 6
19
Fig� 6a
14
Fig� 7
Fig� 8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mt3 pro18081809

Tabla de contenido