Kohler K-8548 Guia De Instalacion página 8

Diverter
Cartridge
Escutcheon
Diverter
Valve Body
Note: Provide Diverter Support
4. Complete the Diverter Installation
CAUTION: Risk of product damage. Verify that the diverter
body is secure before removing the cartridge. If not secured,
the process of removing the cartridge may damage the pipe
and connections.
CAUTION: Risk of product damage. Excessive heat will
damage the internal plastic components. Do not apply
excessive heat while soldering. Direct the torch flame away
from the brass body. Only apply direct heat to the connectors
and extensions.
IMPORTANT! If there is limited access to the solder connections, or
if any other risk of excessive heat being applied to the brass body
exists, remove the cartridge prior to soldering. If you remove the
cartridge, protect the seals and O-rings from becoming dirty,
damaged, or misaligned.
If not already removed, remove the diverter cartridge assembly.
Dry fit all piping and connectors.
Solder piping for the optional spout or wall shower.
Connect the hot and cold lines from the valves to the diverter.
While supporting from below, carefully install and wrench tighten
the cartridge assembly into the diverter body.
Install the diverter handle. Use a hex wrench to tighten the
setscrew.
1000588-2-D
Deck/Rim
8
Diverter Handle
Setscrew
Stem
Escutcheon
Kohler Co.