Transport & Storage - Würth DIGA WO-1/21 Traducción Del Manual De Instrucciones De Servicio Original

Warning
Small amounts of combustible gas
may escape when the gas cartridge is
inserted.
Do not breath in gas, do not smoke. Keep it away
from naked flames or sparks.
If the smell of gas remains perceptible after the gas
cartridge has been inserted, remove the gas cart-
ridge immediately and identify the cause.
Note
The gas cartridge is not emptied com-
pletely. There is always a small amount
of residual gas (pressure gas) in the
gas cartridge.
Loading the magazine (fig. IV)
You can insert up to four magazine strips with
10 fasteners each in the magazine.
Insert the magazine strip as shown in the figure.
■
Draw the follower [12] to the stop and back
■
again until it is in contact with the magazine
strips.
To remove the magazine strip pull back the
■
follower [12]. Actuate the release lever [13]
and draw back the follower [12]. Actuate the
locking mechanism and remove the magazine
strip.
Removing blockages
Remove the battery and the gas cartridge.
■
Remove the magazine strip.
■
Eliminate the blockage.
■
Adjusting the driving depth
Adjust the driving depth of the nail using the setting
wheel [16]:
Rotation to the left: Shallower driving depth
■
Rotation to the right: Greater driving depth
■
The optimal driving depth is to be determined by
trial and error.
Warning
Risk of burns! The sleeve can get very
hot in continuous operation.
Working instructions (fig. V)
Inserting fasteners
Hold the device firmly and stand in a stable
■
position.
Press the device with the sleeve [14] against
■
the material surface.
3 This releases the safety of the device. The fan
motor is switched on and draws in air. Gas is
injected in the combustion chamber.
Caution
Never hold your hand directly in front of the intake
opening since this may cause malfunctions!
Press the actuator.
■
3 The gas mix is ignited electrically and the faste-
ner is driven into the basis.
Note
Ignition is only initiated if the sleeve
[14] is completely pushed in and
if at least three fasteners are in the
magazine.
Release the trigger and remove the device.
■
3 The exhaust gas is discharged via the openings
[11]. Simultaneously fresh air is blown in the
combustion chamber.
Note
If no further fastener is driven in, the
fan continues blowing for approx.
eight seconds and is then switched off.
Warning
The device is designed for continuous
operation. In this process, the sleeve
can get very hot.
If you detect visible defects, immediately stop wor-
king with the device and have it repaired by Würth.
Transport & storage
Danger
At the end of the working day, during
longer breaks, when transporting and
storing, always remove the battery and
the gas cartridges from the device.
Store the device and the battery in the genuine tool
box on a safe, dry, heat- and frost-proof place.
Always store gas cartridges separately and on a
save place. Unauthorized persons, in particular
children, may not get access to the device or to gas
cartridges.
35