Hilti SCM 22-A Manual Del Usuario página 27

5. Remove the clamping screw from the outer clamping flange.
6. Open the pivoting guard by swinging it to the side and then remove the saw blade.
Note
If necessary, the mounting flange can be removed for cleaning.
5.4 Fitting the saw blade
Note
Check that the blade to be fitted complies with the technical requirements and that it is well
sharpened. A sharp saw blade is an essential requirement for a perfect cut.
1. Clean the mounting flange and the clamping flange.
2. Fit the mounting flange onto the drive spindle the right way round.
3. Open the pivoting guard.
4. Fit the new saw blade.
Note
Observe the direction-of-rotation arrow on the saw blade and on the power tool. They must
correspond.
5. Fit the outer clamping flange the right way round.
6. Insert the clamping screw.
7. Insert the hex. socket wrench in the saw blade clamping screw.
8. Press the drive spindle lockbutton.
9. Secure the clamping flange with the clamping screw by turning the hex. socket wrench in the opposite
direction to the direction-of-rotation arrow.
◁ The spindle lockbutton engages.
10. Before using the power tool, check that the saw blade is correctly seated and tightened securely.
5.5 Adjusting the cutting depth
1. Release the cutting depth adjustment clamping lever.
2. Lift the product in a scissor movement and set the desired cutting depth by closing the clamping lever.
5.6 Inserting the battery
WARNING
Risk of injury! Inadvertent starting of the circular saw.
▶ Before fitting the battery, check that the circular saw is switched off and that the safety lock is not
pressed in (i.e. safety lock is active).
WARNING
Electrical hazard! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts on the
circular saw are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the battery is
securely seated in the circular saw.
▶ Push the battery into the product from the rear as far as it will go and until it is heard to engage with a
double click.
4
5
6
21