Procedure If The Chip / Dust Channel Is Blocked - Hilti SCM 22-A Manual Del Usuario

Ocultar thumbs Ver también para SCM 22-A:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
5.7 Sawing along a line
Note
Secure the workpiece to prevent movement.
Position the workpiece so that the saw blade is free to rotate beneath it.
Check to ensure that the on/off switch on the product is in the "off" position.
Position the forward section of the saw's base plate on the workpiece but do not bring the blade into
contact with the workpiece.
1. Fit the battery into the product.
2. While pressing the safety lock, switch the product on by pressing the on/off button.
3. Guide the product along the cutting line on the workpiece at a suitable speed.
5.8 Fitting / adjusting the rip fence (parallel guide)
1. Press the clamp together.
2. Push the parallel guide into the base plate as far as desired.
3. Release the clamp when the parallel guide is in the desired position.
5.9 Emptying the chip collector
WARNING
Risk of injury! Hot or sharp metal cuttings / chips present a hazard.
▶ Wear protective gloves when emptying the chip collector.
1. Remove the battery from the product.
2. Pull the chip collector away from the tool to the rear.
3. Swing the two halves of the chip collector apart and empty out its contents.
4. Push the chip collector onto the guard until in engages in position.

5.10 Procedure if the chip / dust channel is blocked

1. Remove the battery from the product.
2. Remove the chip collector.
3. Clean the chip / dust channel.
Note
Remove the saw blade if necessary.
4. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may
affect operation of the product.
6 Care, maintenance, transport and storage
6.1 Care of the circular saw
WARNING
Electrical hazards. Improper repairs to electrical parts may lead to serious injuries.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Keep the product, especially its grip surfaces, clean and free from oil and grease. Do not use
cleaning agents containing silicone.
▶ Never operate the product when the air vents are blocked. Clean the air vents carefully using a dry brush.
Do not allow foreign objects to enter the interior of the product.
22
7
9
8

Publicidad

Tabla de contenido
loading

Tabla de contenido