Version Screen; Set Up Menu; Zero Resetting; Active From Setting - Bahco TEA003 Instrucciones Originales

4.5 Version Screen

4.6 Set Up Menu

Setting Options
Language: en / fr / de / it / da / es / fi /
sv / no / pt
LCD Contrast: 1 – 255 (Default 160)
ü
LCD Invert: Invert (
Zero: Reset the stored Zero value
Beep: Enable (
Active From: 2.0 to 40.0 % (default 2.0%)

4.7 Zero Resetting

Zero resetting should only be performed if the tester won't zero in Track mode. If this is the case the
transducer may have been overstrained.
If the reading is unstable the tester should be returned to a supplier approved agent for repair. It is
recommended to get the tester recalibrated as soon as possible after resetting the zero.
Make sure no torque is being applied to the tester and remove any tools from the input drive when
resetting the zero.

4.8 Active From Setting

This is the percentage of capacity at which Click mode and Dial mode will start to capture peak values.

4.9 Target Indication

When a target is selected, the tester will indicate whether a reading is Low, Pass or High in three
different ways.
Press and hold
view the version screen
The version screen contains:
P/N (Part Number of the tester)
S/N (Serial Number)
S/W (Software Version Number)
Press
or
Press

) or non-invert ( )
ü 
) or disable ( )
from the measurement screen to
to return to the measurement screen
to enter the set up menu
Select menu item (e.g. Language)
Confirm item
Change setting (e.g. en to fr)
Confirm setting
Select and press
Cancel (exit without saving changes)
to save and exit
7