Calibration; Repair; Cleaning; Warning - Bahco TEA003 Instrucciones Originales

Environment:
Maximum working torsion:
Absolute maximum torsion:
Case materials / finish:
Electromagnetic Compatibility: Designed to comply with EN 61326-1.
Low Voltage Directive
Maximum working torsion:
Absolute maximum torsion:
NOTE: Due to continuous improvement all specifications are subject to change without prior
notice.

6. CALIBRATION

Your instrument has been supplied with a certificate of calibration. To maintain the specified accuracy
it is recommended that the instrument is recalibrated at least once per year. Recalibration should
be carried out by the supplier or by a supplier approved agent, where all the facilities to ensure the
instrument is functioning at maximum accuracy are available.
IMPORTANT: DO NOT REMOVE FRONT PANEL AS THERE ARE NO CALIBRATION SETTINGS
INSIDE.

7. REPAIR

Repair should be carried out by the supplier or by a supplier approved agent, where all the facilities
to ensure the instrument is functioning at maximum accuracy are available.
There are no parts for user repair inside the case.

8. CLEANING

Do not use abrasives or solvent based cleaners.

9. WARNING

If the instrument is used in a manner not specified by the manufacturer, the protection provided by
the equipment may be impaired.

10. DISPOSAL

This symbol on the product indicates that it must not be disposed of in the general
waste.
Please dispose of according to your local recycling laws and regulations.
IP 40. Indoor use within a light industrial environment
120% of rated capacity
150% of rated capacity
Powder coated aluminium housing. Stainless steel transducer shaft
Designed to comply with EN 61010-1.
TRANSIENT OVERVOLTAGES up to the levels of OVERVOLTAGE
CATEGORY II
120% of rated capacity (except 2100 N·m @ 110%)
150% of rated capacity (except 2100 N·m @ 110%)
11