Tools Required For Assembly - DeWalt DWX726 Manual De Instrucciones

DWX726 ROLLING MITER SAW STAND

WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source
before installing and removing accessories, before adjusting or changing set-ups or when making repairs. An
accidental start-up can cause injury.
Components (Fig. A)

WARNING: Never modify the stand or any part of it. Damage or personal injury could result.
1. Mounting rails
2. Foot
3. Wheels
4. Leg extension
5. Hex wrench
6. Vertical lock knobs
7. Horizontal lock knobs
8. Handle
9. Work support extension arm
10. Work support
11. Stop plate
12. Activating lever
13
14
15
16
19
20
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D
CALL US TOLL FREE AT: 1–800–4-D
This rolling miter saw stand is a stand designed to accommodate most miter saws and
to provide portability for those units, both in the field and in the shop. If you have any
problem with alignment or mounting, call 1–800–4-D
hardware bag 1:
13. Axles (2)
14. Bushings (2)
15. Washers (4)
16. Nuts (2)
hardware bag 2:
17. M8 x 16 mm button head
screws (4)
18. Curved washers (4)
19. M6 x 10 mm button head
screw (1)
20. M6 lock washer (1)
21. M8 x 21 mm button head
screw with thread locking patch (1)
22. M8 lock washer (1)
Fig. A
10
12
6
8
9
17
18
21
22
7
5
WALT (1–800–433–9258).
e
WALT (1–800–433–9258).
e

Tools Required for Assembly

• Hex wrench 5
the wrench storage location in the
corner of the stand)
• Adjustable wrench
• 1/2 inch open end wrench
• 3/4 inch open end wrench
• Wire cutting pliers
9
1
3
4
WALT TOOL,
e
English
(supplied, comes in
11
10
6
2
3
1