SOUNDMASTER FUR5005 Manual Del Usuario página 11

1. Use alarm and setup it
•
Rotate the middle big button "Alarm off / AL1 / AL1+2 / AL2" (3) point to AL1
•
Press and hold "Setup" (4), and turn right rotate knob "Set" (2) to set hour.
•
Press "Setup" (4) to confirm, and turn right rotate knob "Set" (2) to set minute.
•
Press "Setup" (4) to confirm, and turn right rotate knob "Set" (2) to choose the Alarm
mode is
shown).
•
Press "Setup" (4) to confirm, and turn right rotate knob "Set" (2) to set the alarm
volume.
•
Press "Setup" (4) to confirm, and turn right rotate knob "Set" (2) to choose the alarm
cycle:
1-7 (all days), 1-5 (workdays), 6-7 (weekends), or 1...2...3... to 7 (single day)
•
Press "Setup" (4) to confirm and exit the setting.
•
Default snooze time is 9 minutes.
•
Same operate to set AL2.
•
Rotate the middle big button "Alarm off / AL1 / AL1+2 / AL2" point to AL1+2 which
can set AL1 and AL2, set way same as separate AL1 or AL2.
2. Using Sleep timer
•
When press " Sleep" (5) button once, show icon (sleep), device will turn on radio
and start countdown since 120 minutes, if want to change the value, press "Sleep"
(5) key once within 3 seconds , press each to decrease every 5 minutes .
•
When sleep timer running, press and hold "Sleep" (5) key to stop it.
3. Using NAP timer
•
When press " NAP" (8) button once, show icon (NAP), device will turn on NAP timer
and start countdown since 120 minutes, once timer end, device will output buzzer
sound immediately ,press " NAP" (8) to stop the sound. If want to change the value,
press "NAP" (8) key once within 3 seconds, press each to decrease every 5 minutes.
•
When NAP timer running, press and hold the "NAP" (8) key to stop it if necessary.
4. Using Date View
•
At standby or FM mode, press "Setup" (4) once key to show the date on display,
press twice show the year, press three times to show the day.
5. Manual start Time update
•
When device work on clock mode
•
Press and hold right rotary knob "Clock update" (2) once to activate RDS time
update function, Icon (Update) flashing
•
Press "Clock update" (2)" once again to exit the function.
6. Dimmer & Dimmer Timer (DT)
•
At the anytime unless during alarm active, press "SNOOZE/DIMMER" (7) will
change status of brightness of display circulate.
•
Device "Dimmer Timer " default to be On, if want to change to be Off, go to next
section " Setup up device for advance" (DT ON = display will be dimmed from 23 to
6o clock automatically)
"bp" = Buzzer or e.g. "87.5" = radio (the last used frequency is
FUR5005 / English Instruction Manual
3