Nice MC200 Instrucciones Y Advertencias Para La Instalación Y El Uso página 16

PROCEDURE C - Memorising a transmitter by means of another transmitter already memorised (memorisation far
from the control unit)
This procedure allows for memorising a new transmitter by means of a second transmitter already memorised in the same control unit. This
enables the new transmitter to receive the same settings as the transmitter already memorised. The procedure does not entail any direct action
on button T2 of the control unit, but its mere execution within its reception range.
01. On the transmitter to be memorised: press and hold the button to be memorised.
02. On the control unit: after a few seconds (roughly 5) the "radio" LED lights up. Release the transmitter key.
03. On the transmitter already memorised: press and release 3 times the memorised button to be copied.
04. On the transmitter to be memorised: press and release once the same button pressed at Step 01.
PROCEDURE D - Deleting a single transmitter (if memorised in Mode 1) or a single transmitter key (if memorised in
Mode 2)
01. On the control unit: press and hold button T2.
– After roughly 4 seconds the "radio" LED lights up steady (continue holding the button down).
02. On the transmitter to be deleted from the memory: press and hold a button(*) until the "radio" LED (on the control unit) emits 5 fast
flashes (or 1 flash if the transmitter or button is not memorised).
(*) Note - If the transmitter is memorised in Mode 1, any button can be pressed and the control unit deletes the entire transmitter. If the trans-
mitter is memorised in Mode 2, it is necessary to press the memorised button that must be deleted. To delete additional buttons memorised
in Mode 2, repeat the entire procedure for each button that must be deleted.
PROCEDURE E - Deleting ALL memorised transmitters
01. On the control unit: press and hold the "radio" button.
– After roughly 4 seconds the "radio" LED lights up steady (continue holding the button down).
– After roughly 4 seconds the "radio" LED turns off (continue holding the button down).
02. When the "radio" LED starts flashing, count 2 flashes and prepare to release the button precisely during the 3
03. After the deletion, the "radio" LED flashes fast.
04. Lastly, the "radio" LED emits 5 long flashes to signal that the deletion has been successful.
15 – English
flash that follows.
rd