Operating Instructions; Introduction; Control Panel; Domestic Hot Water (Dhw) - Ferroli BLUEHELIX TECH RRT 28 C Instrucciones De Uso, Instalación Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Operating instructions

1.1 Introduction

Dear Customer,
BLUEHELIX TECH RRT 28 C is a high-efficiency, low emissions premix condensing heat generator with heat ex-
changer in s/steel and incorporated DHW production, using natural gas or LPG and equipped with a microprocessor
control system.
The sealed chamber unit is suitable for indoor installation or outdoors in a partially protected place (according to EN
15502) with temperatures to -5°C (-15°C with optional frost protection kit).

1.2 Control panel

10
5
8
4
3
13
7
14a
fig. 1- Control panel
Panel legend fig. 1
1
DHW temperature setting decrease button
2
DHW temperature setting increase button
Indication during operation
Heating
A heating demand (generated by the Room Thermo-
stat or Remote Timer Control) is indicated by activa-
tion of the radiator.
The display (detail 12 - fig. 1) shows the actual heating
delivery temperature and, during heating standby
time, the message "d2".

Domestic hot water (DHW)

A DHW demand (generated by drawing hot water) is
indicated by activation of the faucet.
The display (detail 12 - fig. 1) shows the actual DHW
outlet temperature and, during DHW standby time, the
message "d1".
156
BLUEHELIX TECH RRT 28 C
12
17
2
1
14b
6
9
cod. 3541N260 - Rev. 04 - 04/2018
3
Heating system temperature setting decrease button
4
Heating system temperature setting increase button
5
Display
6
"Sliding Temperature" Menu - Reset button
7
Mode selection button: "Winter", "Summer",
"Unit OFF", "ECO", "COMFORT"
8
Eco (Economy) or Comfort mode
9
DHW mode
10
Summer mode
12
Multifunction (flashing during exchanger protec-
tion function)
13
Heating
14a Burner lit (flashing during calibration function
and self-diagnosis phases)
14b Appears when a fault has occurred causing the
unit to shut down. To restore unit operation,
press the RESET button (detail 6)
17
External sensor detected (with optional external
probe)
fig. 2
fig. 3
EN

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido