Safety And Recommendations - S&P KIT EDM-100 12V + CT-12/14 Manual De Instrucciones

ENGLISH
EDM-100 12V AXIAL EXTRACTOR FANS
Suitable for bathroom applications
Thank you for placing your confi dence
in S&P by buying this product. It has
been manufactured in accordance with
current technical safety regulations,
production and quality standards as
laid down by the international Quality
Standard ISO 9001.
Please read this instruction booklet
carefully before installing or operating
the product. It contains important
information on personal and user
safety measures to be followed whilst
installing, using
maintenance work on the equipment.
Once the product has been installed,
please pass this booklet to the end
user.
Check that the product is in perfect
condition whilst unpacking. Any fault
or damage caused in origin is covered
by the S&P guarantee. Please make
sure that the product corresponds to
the one you have ordered and that the
details on the instruction label fulfi ll your
requirements.
IMPORTANT:
BE SURE TO HAVE READ AND
UNDERSTOOD THESE INSTRUCTIONS
BEFORE BEGINNING
INSTALLATION PROCESS

SAFETY AND RECOMMENDATIONS

- All wiring must comply with Building
Regulations and the current I.E.E.
Wiring Regulations (BS7671) or the
equivalent standards for your country.
The fi nal installation
examined and tested by a competent
person.
- This fan is IPX4 rated and can be
installed within reach of a person
and carrying
THE
should
using a fi xed bath or shower; however
the fan must not be placed where it
can be submerged in water.
- Do not install near sources of heat in
excess of 40°C.
- This appliance is not intended for use
by young children or infi rm persons
unless they have been adequately
supervised by a responsible person to
ensure that they can use the appliance
safely. Young children should be
supervised to ensure that they do not
play with the appliance.
INSTALLATION
out
IMPORTANT: before installing and
wiring the unit, ensure that the mains
supply is disconnected.
EDM-100 should only be used in
conjunction with fi xed wiring.
Fig.1
The EDM-100 12V is suitable for wall,
ceiling (fi g.2) or window (using the EDM-
100 window kit) installations.
Panel Model
- Drill a 105mm-diameter hole in chosen
position in the panel surface.
- Loosen the screw (4), which holds the
grille in place (1) and remove grille.
- Mark the fi xing holes in the back
of the fan plate. This fan must be
be
installed by a competent person.
Complete electrical wiring of fan as
outlined in the Wiring Instructions
overleaf. Then refi t the grille and
tighten the screw (4).
1 – Grille
2 – Cable entry point
3 – Connection cover
4 – Fixing screw
5 – Connection terminals
6 – Outlet
7 – Slot