Resistance Measurement (Ω) - Minipa ET-3702A Manual De Instrucciones

D. Resistance Measurement (Ω)
Figure 6
WARNING
To avoid damages to the meter or to the devices under test, discon-
nect the circuit power and discharge all high voltage capacitors before
taking resistance measurement.
Set the rotary switch to Ω. Use the RANGE key to manual selection between
the 400Ω, 4kΩ, 40kΩ, 400kΩ, 4MΩ and 40MΩ ranges.
Note
• Make sure there is no Voltage in the circuit or device under test.
• The display will show OL when the circuit or device under test is opened,
or when the resistance value is higher than selected range.
34