Gardena ErgoJet 3000 Instrucciones De Empleo página 23

Ocultar thumbs Ver también para ErgoJet 3000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 115
Starting the blower:
p
Working positions:
WARNING:
extension cord. Wait until the impeller has completely stopped turning,
then remove the vacuum tubes. Carefully reach into the vacuum opening
and clear out the clogged debris.
This will reduce possible personal injury from the impeller.
9332-20.960.01.indd 23
Switching the blower on:
Move the ON/OFF switch
unit.
a
NOTE: The motor speed can be increased or decreased by using
the variable speed control
CAUTION: To avoid causing damage to the unit, only use the
variable speed control in blow mode. DO NOT attempt to use the
variable speed control in vacuum mode. Lower speeds during
vacuum use could allow debris to build up, stall the motor and
cause unit failure.
Switching the blower off:
To stop the unit, move the ON/OFF switch
OFF (0) position.
Blow mode
Use your unit as a blower for sweeping debris or grass clippings
from driveways, sidewalks, patios, etc. Also, for blowing grass
clippings, straw, or leaves into piles, or removing debris from
corners, around joints, or between bricks.
Use the variable speed control to increase or decrease the motor
speed during blower use. Direct air flow by directing the blower
tube down or to one side.
Always work away from solid objects such as walks, large stones,
vehicles, and fences.
Clean corners by starting in corners and moving outward. This will
help prevent an accumulation of debris which could fly into your
face. Be careful when working near plants. The force of the air
could damage tender plants.
Vacuum mode
Use your unit as a vacuum to pick up dry material such as leaves,
grass, small twigs, and bits of paper.
For best results during vacuum use, operate your unit at high
speed.
Move slowly back and forth over the material as you vacuum.
Avoid forcing the unit into a pile of debris as this can clog the unit.
Keep the vacuum tube about an inch above the ground for best
results.
If the unit becomes clogged, stop the unit and unplug the
p
to the ON (I) position to turn on the
a
.
p
to the
23
04.01.12 07:47

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

9332-20

Tabla de contenido