Tabla de contenido
Publicidad
Section 3 Installation
Circulation
3-26
External
The plumbing connections for external circulation are located on the rear
of the immersion circulator.
application.
side). The connections are 16 mm O.D. Remove the union nuts and plates
to install the 8 mm or 12 mm hose barbs and clamps supplied with the
circulator.
Remote Temperature
Sensor (See next page)
Outlet Flow
To prevent damage to the circulator's plumbing, use a 19 mm
backing wrench on the nut when removing/installing the external
connections.
is the outlet flow to the external application (supply
USB Port
(See next page)
is the return flow from the external
Connections (Typical)
Multifunction Port
(See next page)
Return Flow
Thermo Scientific
Publicidad
Tabla de contenido
