Kobalt KR 124B-03 Manual De Instrucciones página 12

OPERATING INSTRUCTIONS
5. LED Worklights
The tool has 2 built-in worklights (I), located
around the collet; these provide high visibility of the
workpiece when cutting. These lights are always
"on" when the tool is turned on.
6. Vacuum Adaptor
The tool is equipped with a vacuum adaptor
(K), which is sized to accept a 1-1/4 in. (3.2 cm)
vacuum-hose adaptor (not included).
To attach the adaptor onto the fixed base (C),
position and then secure it to the fixed base with
the knob.
7. ON/OFF Switch
a. To turn the tool ON, push the ON/OFF switch
(A) to the "I" position for "ON".
b. To turn it OFF, push the ON/OFF switch to the
"O" position for "OFF".
Always hold the tool and cutter bit away from the
workpiece when turning on the switch.
WARNING
• Only allow the tool and cutter bit to come into
contact with the workpiece after it has reached
full speed.
• Only remove the tool and cutter bit from
the workpiece after turning the it "OFF"
("O"position), and after the cutter bit comes to a
complete stop.
Soft Start Feature
The soft-start feature minimizes torque twist, which is customary in larger router motors, by
limiting the speed at which the motor starts. This increases the life of the motor.
5
6
K
7
A
12
L