Kobalt KR 124B-03 Manual De Instrucciones página 14

OPERATING INSTRUCTIONS
d. Move the tool while keeping the edge guide (M)
flush with the side of the workpiece.
e. When the cut is complete, turn the motor "OFF"
and allow the cutter bit to come to a complete
stop before removing it from the workpiece.
f. Remove the battery, place the tool on the
worktable, and inspect the finished cut.
If the distance between the side of the workpiece
and the cutting position is too wide for the edge
guide, or if the side of the workpiece is not straight.
In this case, firmly clamp a straight board to the
workpiece and use it as a guide against the router
base. Feed the tool in the direction of the arrow.
NOTICE: Arbor-type bits with pilots are excellent
for shaping the edge of any workpiece that is either
straight or curved, if the curvature is at least as
great as the radius of the bit to be used.
WARNING
• Always clamp the workpiece securely and keep
a firm grip on the tool base with both hands at
all times. Failure to do so could result in loss of
control, causing possibly serious personal injury.
• Removing the cutter bit from the workpiece while
it is still rotating could damage the workpiece and
result in loss of control, causing possibly serious
personal injury.
10a
10b
10c
14
M
Guide
Center hole