Kobalt KR 124B-03 Manual De Instrucciones página 17

OPERATING INSTRUCTIONS
Feeding too quickly
Forcing the feed of the cutter bit forward too
quickly slows the rotational speed of the cutter bit
and the bit takes larger bites as it rotates, causing
splintering and gouging of the workpiece. This
forcing action can also cause the router motor to
overheat.
The high speed of the cutter bit during a proper
feeding operation (left to right) results in very little
kickback under normal conditions.
Kickback may damage the workpiece and could
result in losing control of the tool, causing possible
personal injury.
Feeding too slowly
When the cutter bit is fed too slowly, the rotating
cutter bit does not cut into new wood rapidly
enough to take a bite. Instead, it scrapes away
sawdust-like particles. This scraping produces
heat, which can glaze, burn, and mar the cut in the
workpiece, and in extreme cases, can overheat the
cutter bit.
12c
Feeding too quickly
12d
Feeding too slowly
17