Bosch 1639 Instrucciones De Funcionamiento Y Seguridad página 8

BM 2610915206 10/03 10/15/03
ATTACHING CIRCLE CUTTING GUIDE
(Model 1639K only)
Your tool is equipped with a circle cutting
guide that can easily be attached directly to
the depth guide, or the optional dust hood
accessory.
To attach, position depth guide, or dust
hood as shown, push down on release
button and slide depth guide or dust hood
onto circle cutting guide until it snaps into
place.
To remove, simply press release button and
slide off in direction of arrow (Fig. 5).
ATTACHING TEMPLET GUIDE
(Not included, available as accessory)
Using a template lets you duplicate designs
or letters uniformly time after time. This
technique requires the use of an accessory
templet guide
To attach, simply push onto the bottom of
the depth guide, or the dust cover.
To remove, pull on tab and remove (Fig.1).
DEPTH GUIDE ADJUSTMENT
Use the depth guide to adjust the depth of
cut. Simply loosen (counter clockwise) the
knob (approximately 1 turn) and slide the
depth guide in or out to
the desired depth of
cut (about 1/8" greater
than material thickness)
and retighten the knob
(clockwise) (Fig. 6).
DEPTH GUIDE
LOCKING KNOB
FIG. 6
4:24 PM Page 8
FIG. 5
DEPTH
GUIDE
RELEASE
BUTTON
ATTACHING DUST HOOD
(Not included, available as accessory)
The dust hood is sized to accept 35mm
vacuum hoses.
To Attach, position dust hood as shown,
push onto depth guide until it lock into
place.
To remove, squeeze tabs on dust hood and
pull off depth guide (Fig. 1).
Operating Instructions
(Not included, available as accessory)
The dust hood is sized to accept 35mm
vacuum hoses. The dust hood accessory
includes the VAC002 adapter that will
connect the dust cover to 1-1/4" and 1-1/2"
vacuum hoses. An adapter to connect the
hood to 2-1/2" hoses is also available
separately.
(Not included, available as accessory)
Templet guides are used for cutting
repeated patterns, special designs, inlays,
and other applications.
A templet pattern may be made of plywood,
hardboard, metal or even plastic, and the
design can be cut with your rotary cutter,
jigsaw, or other suitable cutting tool.
Remember that the pattern will have to be
made to compensate for the distance
between the bit and the templet guide (the
"offset"), as the final workpiece will differ in
size from the templet pattern by that
amount, due to the bit position.
-8-
DUST
HOOD
CIRCLE
CUTTING GUIDE
DUST HOOD
TEMPLET GUIDE